Filter
Top Products
9. The update is finished when "Firmware Update Done. Please Reboot Engine." appears.
10. Turn the main power of the machine off, and then back on.
Updating the Boot Loader Firmware
This is also listed on the configuration page, but this firmware is not updated in the field.
Updating Failure
If the firmware update is not successful, the update process is suspended and an error message should
display on the FW Update Tool screen. If this happens, DO NOT turn off the machine, and execute the
update procedure again (unless the error message "Downloaded file is broken! Do NOT use print, scan,
fax and copy function at the same time." is displayed).
If power is turned off accidentally during a firmware update, the firmware will not be correctly updated,
and the machine may not start up normally. If the machine does not start up normally, the controller firmware
and/or the engine firmware will need to be updated again.
When the machine does not start up normally, in most cases, the panel display will indicate one of the
following two conditions:
• When attempting to restart the machine, the LCD panel display indicates "Initializing" indefinitely.
In this case, the controller firmware update has failed. The controller firmware must be updated again.
• When attempting to restart the machine, the LCD panel display indicates "Please Download Engine
FW Again!"
In this case, the engine firmware update has failed. The engine firmware must be updated again.
FW Update Tool Messages
FW Update Tool Messages: Information
Message for USB update
Messages Comment Action
USB Upload : End of data
Send F/W file to MFP successfully.
(Transmission Time: <30 sec)
Please reboot MFP after panel
shows reboot message.
5. System Maintenance Reference
112
5