Filter
Top Products
Switch 00 - Home position settings
Digit Purpose
0
Marker 0: Off
1: On (successfully scanned documents will be marked)
1
2
Contrast Bit 2 Bit 1 Setting Bit 2 Bit 1 Setting
0 0 Normal 1 0 Darken
0 1 Lighten 1 1 Darken
3
4
Resolution Bit 4 Bit 3 Setting Bit 4 Bit 3 Setting
0 0 Standard 1 0 Fine
0 1 Detail 1 1 Fine
5
Transmission mode 0: Memory transmission
1: Immediate transmission
6
If you change any of the contrast, resolution, transmission mode, marker, or halftone
settings before making a transmission, then:
0: The setting(s) will not return to the home position after the transmission.
1: The setting(s) will return to the home position after the transmission.
7 Halftone 0: Off 1: On
Switch 01 - Printing of various items on received messages
Digit Purpose
0
Mark to distinguish messages that were sent to your machine through a forwarding
station (Memory card or hard disk required)
0: Off 1: On
1 Center mark 0: Off 1: On
2 Reception time 0: Off 1: On
3 Do not change this setting.
4 Checkered mark 0: Off 1: On
5
Printing of the Command Information Line (ISDN kit required)
0: Off 1: On
This has the same effect as the TTI On/Off setting.
6, 7 Do not change these settings
Switch 02 - Automatic printing of reports
Digit Purpose
0
Transmission result report (memory transmission)
0: Off 1: On
1 Do not change this setting.
2 Memory storage report 0: Off 1: On
3 Polling reserve report 0: Off 1: On
4 Polling result report (polling reception) 0: Off 1: On
5
Transmission result report (immediate transmission)
0: Off 1: On
6 Polling clear report 0: Off 1: On
7 TCR 0: Off 1: On
Forwarding mark:
SECTION 4. PROGRAMMING THE MACHINE
73