Filter
Top Products
ii
Chapter 2
Basic Operations
Workflow ........................................................................... 2-2
Turning the Power ON/OFF .............................................. 2-3
Turning the Power ON ......................................................2-3
Turning the Power OFF ....................................................2-4
Setting a Media ................................................................. 2-5
Adjusting the Head Height ................................................2-5
Note for media setting .......................................................2-7
Setting a roll media ...........................................................2-8
Take-up device ...............................................................2-13
Setting leaf media ...........................................................2-14
Changing the printing origin ............................................2-16
Preparing for the Heaters ............................................... 2-17
Changing the Temperature Settings for the Heaters ......2-17
Checking the Heater Temperature .................................2-18
Changing the Temperature Settings for the
Drying Heater ..................................................................2-18
Test Feeding ................................................................... 2-19
Test Printing .................................................................... 2-20
Test Printing ....................................................................2-21
Head Cleaning ................................................................ 2-22
About head cleaning .......................................................2-22
Perform head cleaning depending on the test printing
result ...............................................................................2-22
Set the media feeding ..................................................... 2-23
Setting Feed Correction ..................................................2-23
Correct the ink drop position for bidirectional printing ..... 2-25
Printing Data ................................................................... 2-27
Checking the Status of Ink Cartridges ............................2-27
Checking the Status of Waste Ink Bottle ........................2-27
Starting a Printing Operation ..........................................2-28
Stopping a printing operation halfway .............................2-29
Deleting Received Data (Data Clear) .............................2-29
Behavior after printing has been completed ...................2-29
Cutting a media ...............................................................2-30
When [NEAR END] error occurs while printing ...............2-30
When [INK END] error occurs while printing ...................2-30
When a waste ink bottle confirmation message
appears while printing .....................................................2-31
Chapter 3
Extended Functions
List of Functions ................................................................ 3-2
Setting Logical Seek ......................................................... 3-3
Setting Drying Time .......................................................... 3-4
Setting Margins ................................................................. 3-5
Perform setting to reduce stripes between passes ........... 3-6
Setting Auto Cleaning ....................................................... 3-7