Filter
Top Products
2-15
1
2
Basic Operations
4
5
6
Setting a Media
6
Hold the media with the media guide gently.
• If the printing result indicates that drying is not enough, use
the media guide to improve adhesion of the media to the
Media Transfer Surface.
• Use the media guide with it hit slightly against the sheet
holder.
• Make the media pass around the center of the claw of the
media guide.
7
Close the front cover.
8
Press the key.
9
Press the key to select "LEAF" .
10
The media detection is started.
(1) The media width is detected.
(2) The media is fed then the rear end of media is detected.
(3) It returns to the local mode when the detection is completed.
Notes when using media press
• In case that you use 240-mm wide or narrower media, media cannot be detected if it is set in
accordance with . Set media approximately 30mm inner than .
•
Do not set the media outside . As media may tilt and be lifted, it could break the head.
• If a media is misaligned to the right more than fixed position, a
warning is displayed. Set the media again.
Media guide
MED I A SELECT
ROL L< > LEAF
** MEDIA DETECT **
Do not set outside
this mark.
Media
Media Press
ERROR 516
MED I A SET POS I T I ON R