Filter
Top Products
Troubleshooting
Operational Difficulties
Operational Difficulties
Problem
STANDBY MODE
Nothing happens when the switch is
turned on.
Required Action
SET DOC. OR DIAL NO. is not
displayed.
The display does not show the
Ready condition, or the machine
stops during operation.
Check the power cord. Is it properly plugged into
the outlet?
* Plug it in firmly
Switch the power on.
> If the Power indicator does not light, check
that the power cord is plugged in.
The machine might be the Energy Saver mode.
* Hold the Energy Saver key for two seconds.
Does CLEAR ORIGINAL or CLEAR COPY
appear in the display ?
* Clear the misfeed. See page 102.
Does ADD PAPER appear in the display?
* Load paper into the paper tray. See page 80.
Does CLOSE COVER appear in the display?
* Close all covers.
TRANSMISSION
Is the Add Toner indicator on?
% Load a new toner cartridge. See page 86.
The original is not pulled into the
auto document feeder.
You did not feed the document far enough into
the feeder.
* Insert the document into the feeder until it
stops. Retransmit.
Clean the ADF rollers (see page 95).
* If the same problem still exists after user
maintenance, contact your service
representative.
The machine cannot dial out.
The telephone line is disconnected.
- Check that the line is connected properly.
The telephone line type setting is incorrect.
* Check the telephone line type setting
See page 143.
110