Filter
Top Products
Troubleshooting
Displayed Error Messages
Displayed Error Messages
CHECK AUTO-DIALING
NO FILE EXISTS
TOO MANY DEST.
USED AS GROUP
USED AS DIAL
USED AS TONE KEY
USED AS GROUP KEY
NOT PROGRAMMED
ALREADY PROGRAMMED
PLEASE SET PAUSE
ADD TONER
ADD PAPER
CLEAR ORIGINAL
CLEAR COPY
CLOSE COVER
UNABLE USE PRINTER
You cannot use the auto-dialer at the moment. Use the
ten-key pad or the handset.
No polling reception operations have been programmed.
There are no messages in memory waiting for
transmission.
Incorrect file number. Check the file number and try again.
The memory cannot hold any more telephone numbers.
Either: Delete some numbers then try again.
Or: Wait until some of the Send Later or other delayed
transmissions waiting in memory have been carried out,
then try again.
This Quick Dial Key has a Group stored in it.
This Quick Dial Key has a telephone number stored in it.
This Quick Dial Key is programmed as Tone Key.
This Quick Dial Key is programmed as Group Key
This Quick Dial Key or Speed Dial Code does not contain
a number.
Either:
This number is already included in this Group.
This RTI/CSI has already been stored for use with this
feature.
You must add a pause after your area code when you input
your fax terminal’s own telephone number.
The toner cartridge is empty. Install a new cartridge.
The cassette is now empty.
Either:
- A document is jammed in the feeder.
- The ADF exposure glass or the white plate might be dirty.
Clean it as descrived on page 96. If this message still
appears, please contact your service representative.
Paper is jammed in the printer.
A cover is not closed properly. Check that all covers are
closed.
Machine cannot print a list/file, because the heater is not
warm enough or plotter is not ready.