Filter
Top Products
27
Operations
Turn the power off
1
Press the ON/STANDBY button.
When the beep sound setting is [
On
], the projector beeps, and a message appears,
confirming that you wish to shut off the power. To shut off the power, press the ON/
STANDBY button again. If you do not wish to shut off the power, wait for a while without
conducting any operations. The message will disappear after a moment and the
operation will no longer be valid.
2
Press the ON/STANDBY button again.
When the beep sound setting is [On], the projector
beeps, and the screen disappears, but the internal
cooling fan continues to operate. The projector will
then go into standby mode.
During cooling, the ON/STANDBY indicator flashes.
While the indicator is flashing, the power cannot be
turned back on. There is no problem with unplugging
the power cord in this state.
3
Replace the lens cap.
After use, replace the lens cap.
Note
The projector consumes about 4.5 W of power in standby. We recommend that you
unplug the power cord if you will not be using the projector for an extended period.
When [Network standby] is [On], it consumes about 8 W during standby.
Precautions
If you wish to restart the projector again right after turning off the power, give the lamp
time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it may
fail to light.
Right after turning off the power, the unit may become very hot, especially the air
exhaust, lamp cover or bottom of the unit. Please handle with care to avoid burn injuries.
•
•
•
Control panel
Remote
control