Filter
Top Products
xClearing Misfeeds
119
6
x
xx
x
Clearing Misfeeds
R
CAUTION:
Important
❒ When clearing misfeeds, do not turn off the operation switch. If you do, your
copy settings will be lost.
❒ To prevent misfeeds, do not leave any torn scraps of paper inside the ma-
chine.
❒ If paper misfeeds occur frequently, contact your service representative.
Note
❒ More than one misfed area may be indicated. When this happens, check all
the areas indicated. See the following charts:
• A, B, C,D,Y⇒ p.120
• R (500-Sheet Finisher)⇒ p.123
❒ Inside the finisher, or inside the front cover, there is a sticker explaining how
to remove misfed paper.
❖
❖❖
❖ If paper is stuck to the printer's right side heat roller
When you open the internal cover of the duplex unit (right side of the ma-
chine), you can see the holes in the upper surface of the development unit (the
part with the warning label). Normally, from here you will be able to see the
orange heat roller. If you can see paper in this area, contact your service rep-
resentative.
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
ThemisC1_AE_zentai_pre_FM.book Page 119 Thursday, July 28, 2005 2:13 PM