Filter
Top Products
5
Hexagonal wrench
(3 mm)
Head
retainer 1
Caps
Head retainer 2
Hexagonal wrench
(2.5 mm)
Head retainer 3
Hexagonal wrench
(3 mm)
5. Installation and Cable Connections
Removing the Head Retainers and Installing
Lifting and carrying are operations that must be carried out by two persons, by grasping the bottom of the
machine. Failing to do so may result in injury.
Be sure to remove the head retainers before use. Failure to remove them may not only impede operation, but may cause
breakdown.
Do not attempt to touch any internal area other than the items described below, or to use excessive force to move any item.
Doing so may result in breakdown.
After you take the machine out of the carton, the
first thing you need to do is to remove the head
retainers. Carry out this operation before you
connect the AC adapter. When transporting the
machine, reattach the head retainers. Store the
head retainers in a safe place so that they do not
get lost.
1. Use the hexagonal wrench (3 mm) to
remove the three screws, then detach
head retainer 1.
2. Attach the three included caps.
3. Open the door. The blue panel visible to
the right of the table at the back is head
retainer 2. Use the hexagonal wrench
(2.5 mm) to remove the five screws, then
detach head retainer 2.
4. Remove head retainer 3, which is blue
and located at the top of the head unit.
Use the hexagonal wrench (3 mm) to
remove one screw, then pull head
retainer 3 up and out to extract it. Take
care not to drop the retainer when
extracting it.
When installing, be careful of the following points.
• Do not install in an unstable location. Doing so may not only lead to danger of falling, but may result in breakdown or
malfunction.
• Avoid use in locations exposed to large amounts of electrical noise, such as areas near motors.
• Do not install in a location exposed to high humidity or dust.
• Because the machine generates heat when in use, do not install in a location where heat radiation is poor.
• Do not install in locations exposed to severe vibration.
• Use in an environment where temperature is between 10 ˚C and 40 ˚C (between 50 ˚F and 104 ˚F) and relative humidity is
between 35 % and 85 % (with no condensation).
• Avoid using in an environment exposed to severe changes in temperature. Such use may affect scanning accuracy.
4. Names and Functions 5. Installation and Cable Connections