Filter
Top Products
Part 1 Startup
8
Standby key
6.
Switching the Power On and Off and Opening and Closing the Door
Steps for Switching On the Power
There is a proper procedure for switching on the power to the machine. Follow the steps
below.
1. Close the door.
2. Press the Standby key.
3. The Movement LEDs flash. Keep the door closed until the flashing stops.
During this interval, the machine is performing initialization.
4. When initialization ends, the Standby key lights up green and the Move-
ment LEDs go dark. Scanning is now possible.
Initialization may take up to about 40 seconds. If the door is opened during initialization, operation is interrupted to ensure safety.
In such cases, correct scanning cannot be performed. Switch off the power, close the door, then switch the power on again. Also,
sound that is differ from what you usually hear may be heard for several seconds during initialization, but this does not indicate
a malfunction.
Starting the computer after switching on the machine may make it impossible to perform scanning. This may occur depending
on the computer, but does not indicate a malfunction. If this happens, start the computer first, and then switch on the power to the
machine. Also, if the computer is restarted, reset the power to the machine as well.
Switching Off the Power
When the machine will not be in use for a prolonged period, unplug the power cord from the electrical outlet.
Failure to do so may result in deterioration of the insulation, leading to electrical shock, short circuit, or fire.
Hold down the Standby key for 1 second or longer.
Opening and Closing the Door
When you open the door, the Standby key flashes green. Scanning cannot be performed while in this state. Close the door, then start
scanning.
To ensure safety, an emergency stop occurs when the door is opened while scanning is in progress. Scanning cannot be resumed even after
the door is closed.
If the Standby key does not flash when you open the door, the safety device may have failed. If this happens, immediately stop
use and contact your authorized Roland DG Corp. dealer or service center.
Movement LEDs