Filter
Top Products
Part 1 Startup
10
Steps for Installing and Setting Up the Programs
1. Insert the included CD-ROM (Roland Software Package) into the
computer's CD-ROM drive. The setup menu appears automatically.
2. Click the place that says "Click here," then select "LPX-250."
3. Click the [Install] button.
4. Follow the on-screen setup instructions, clicking the [Next] button to
proceed. If you want to specify a particular folder for installation, do it
here. In most cases you can simply click [Next] to proceed. Installation
starts.
5. When all installation and setup finishes, the final window appear. Click
[Close] to finish setup.
Starting Dr. PICZA3
1. First switch on the power to the LPX-250.
2. Next, in Windows, click the [Start] button, then click [Programs], then [Roland PICZA], then [Dr. PICZA3].
When Dr. PICZA3 starts, it attempts to verify the name of the model of the 3D scanner that is connected. Be sure to turn on the LPX-250
before you run Dr. PICZA3.
With this system, the [Run MODELA Player] and [Run 3D Engrave] buttons in Dr. PICZA3 are not used. Use them when you are using
together with the MODELA series or the like.
Selecting the Communication Port
1. In Dr. PICZA3, go to the [File] menu and click [Preferences].
2. For [Port], select the number of the COM port on the computer to which
the LPX-250 is connected.
3. Click [OK]. The LPX-250 can now perform scanning.
Special Notes for Windows NT 4.0/2000
Care is required when another printer driver or the like is set to use a COM port. Scanning cannot be performed when the same COM port is
selected for the other driver and Dr. PICZA3. Take action such as connecting to a different COM port to avoid conflicts with the other driver.
Checking the Connection
In Dr. PICZA3, go to the [Help] menu and display [About]. If the firmware version and model name are displayed, the connection is correct.