Filter
Top Products
Setting the KELVIN
Use this procedure to set color tone produced by the plasma display.
Example: Setting “6500K”
Press the MENU button on the remote control to display the MAIN MENU on the screen, then...
1. Use the
and buttons to select “PICTURE ADJUST”, then press the MENU button. The “PICTURE
ADJUST” screen appears.
2. Use the and buttons to select “KELVIN”.
3. Use the and buttons to select “6500K”.
The mode switches as follows when the and buttons are pressed:
5400K 6500K 8500K 9300K
* See below to set “WHITE BALANCE ”.
* If neither the or button is pressed within 5 seconds, the current selection is set and the previous screen
reappears.
4. Once the setting is completed...
Press the EXIT button to return to the main menu. To delete the main menu, press the EXIT button once more.
24
KELVIN : 6500K
GAMMA : 2.2
DITHER : AUTO
COLOR CHART
PICTURE ADJUST
2 / 2
PREVIOUS PG
SEL. ENTER RETURN
MENU/ENTER
EXIT
Information
■ Setting the color temperature
5400K ................ Redder
6500K ................ Slightly redder
8500K ................ Standard (slightly bluer)
9300K ................ Bluer
■ Restoring the factory default settings
Select “FACTORY” under the INSTALL 1 menu. Note that this
also restores other settings to the factory defaults.
OSD (On Screen Display) Controls