Filter
Top Products
56
OSD (On Screen Display) Controls
LUM SET LINK
Use this function to set a uniform brightness for each display.
Turn on the AUTO ID before the following operations.
Example: Setting “ON”
Perform Steps 1-2 of VIDEO WALL, then...
3. Use the and buttons to select “LUM SET LINK”.
4. Use the and buttons to select “ON”, then press the MENU button.
The mode switches as follows each time the or button is pressed: OFF ON
DIVIDER : OFF
POSITION
DISP. MODE : SPLIT
AUTO ID
IMAGE OPT
P.
ON DELAY : OFF
LUM SET LINK : OFF
REPEAT TIME : OFF
VIDEO WALL
SEL. ADJ. RETURN
EXIT
Information
■ LUM SET LINK settings
ON ...... Sets a uniform brightness for each screen in a 2x2 video wall.
OFF .... Sets the individual screen brightness for each screen in a 2x2 video wall.
* Set “OFF” in a 3x3 video wall.
* When this function is set “ON”, connect your plasma displays with the remote cable (optional) in the
order of the position numbers for the 2x2 video wall. See the drawing below.
* If there are changes in the DIVIDER or POSITION, the LUM SET LINK will automatically turn OFF.
NOTE:
The remote control can not be operated unless the IR ENABLE is set to “OFF”.
No. 1 No. 2
No. 4 No. 3
No. 1 No. 2
No. 4 No. 3
No. 1 No. 2
No. 4 No. 3
No. 1 No. 2
No. 4 No. 3
Display 1 Display 2
Display 4 Display 3
REMOTE
IN
REMOTE
OUT
REMOTE
OUT
REMOTE
IN
REMOTE
OUT
REMOTE
IN
REMOTE
OUT
REMOTE
IN