Filter
Top Products
57
OSD (On Screen Display) Controls
REPEAT TIME (REPEAT)
Use this to set two timers. Each timer can use the DIVIDER, SOURCE and ACTIVE functions.
Turn on the AUTO ID before the following operations.
Example:
TIMER1... VIDEO1 will be displayed for 3 minutes.
TIMER2... RGB1 will be displayed for 6 minutes in a 2×2 video wall.
Perform Steps 1-2 of VIDEO WALL, then...
3. Use the and buttons to select “REPEAT TIME”.
4. Use the and buttons to select “ON”, then press the MENU button. The “REPEAT TIME” screen appears.
5. Adjust using the and buttons.
The mode switches as follows each time the or button is pressed:
• DIVIDER
1 4 9
• SOURCE
The available sources depend on the setting of “BNC INPUT”.
→RGB: → VIDEO1 ↔ VIDEO2 ↔ VIDEO3 ↔ HD/DVD ←
→ RGB3 ↔ RGB2 ↔ RGB1 ↔ HD/DVD2 ←
• ACTIVE
00H01M 00H02M 00H03M .... 04H14M 04H15M
6. Once the setting is completed...
Press the EXIT button to return to the VIDEO WALL screen.
DIVIDER : OFF
POSITION
DISP. MODE : SPLIT
AUTO ID
IMAGE OPT
P.
ON DELAY : OFF
LUM SET LINK : OFF
REPEAT TIME : OFF
VIDEO WALL
SEL. ADJ. RETURN
EXIT
Information
■ REPEAT TIME settings
If you set both timers, Timer 1 and Timer 2 run consecutively.
In the case of the Video Wall, timer No. 1 can be used to control
all the displays simultaneously.
* This becomes effective when the on-screen menu goes out.
1 DIVIDER : 1
SOURCE : RGB1
ACTIVE : 00H03M
2 DIVIDER : 4
SOURCE : RGB1
ACTIVE : 00H06M
REPEAT TIME
SEL. ADJ. RETURN
EXIT
■ Restoring the factory default settings
Select “FACTORY” under the INSTALL 1 menu.
Note that this also restores other settings to the factory defaults.