Filter
Top Products
43
OSD (On Screen Display) Controls
IMAGE SWEEP
When this is set to ON, a white vertical bar moves repeatedly from the left and of the screen to the right end at a
constant speed.
Example: Setting “IMAGE SWEEP” to “ON”
Perform Steps 1-2 of PDP PROTECT, then...
3. Use the and buttons to select “IMAGE SWEEP”.
4. Use the and buttons to select “ON”. The mode switches as follows each time the or button is pressed:
OFF ON
Setting the time for IMAGE SWEEP
Set a time duration and the speed.
Example: Setting to that the IMAGE SWEEP mode starts
in 30 minutes and proceeds for one hour and a half.
Perform Steps 1-3 of IMAGE SWEEP, then...
4. Use the and buttons to select “ON”, then press the
MENU button. The “IMAGE SWEEP” screen appears.
5. Adjust the time using the and buttons. The mode switches as follows each time the or button is
pressed:
• ACTIVE
ON 00H03M 00H06M ...... 12H42M 12H45M
• STANDBY
00H03M 00H06M 00H09M ...... 12H42M 12H45M
• SPEED
1 2 3 4 5
6. Once the setting is completed...
Press the EXIT button to return to the IMAGE SWEEP screen.
LUM. SETTING : AUTO
ORBITER : OFF
INVERSE : OFF
IMAGE SWEEP : OFF
SOFTEN : OFF
PDP PROTECT
SEL. ADJ. RETURN
EXIT
Information
■ IMAGE SWEEP
ON ........ The white vertical bar appears.
You can set the time by pressing the MENU button while
“ON” is set.
OFF........ Image sweep mode does not funtion.
ACTIVE : 01H30M
STANDBY : 02H00M
SPEED : 1
IMAGE SWEEP
SEL. ADJ. RETURN
EXIT
Information
■ Setting the time
ACTIVE ........ Set the time duration for “IMAGE SWEEP”. When the ACTIVE is set to “ON” the mode will stay on.
STANDBY .... Set the standby time until the “IMAGE SWEEP” mode starts.
SPEED ......... Set the moving speed for the “IMAGE SWEEP”. The speed decreases as the number increases.
* The “STANDBY” can not be set when the “ACTIVE” is ON.
* The “ACTIVE” and “STANDBY” can be set for up to 12 hours and 45 minutes in units of 3 minutes.