Filter
Top Products
C.10
7
Press the
Upper Level
button ( ), then use the scroll
button ( ).
8
Press the
Enter
button ( ) when “IP Get Method”
displays.
9
Press the scroll button ( or ) until “DHCP” displays,
and press the
Enter
button ( ).
10
To assign the address from the BOOTP server, press the
Enter
button ( ) when “BOOTP” displays.
11
Press the
On Line/Continue
button ( ) to return to
ready mode.
Configuring IPX Frame Types
On IPX/SPX protocol networks (for example, Novell NetWare),
the format of the network communication frames must be
specified for the printer. In most cases, you can keep the default
setting “Auto”. However, you can manually set the frame type
format, if required.
•
Auto
(default): Automatically senses and limits the frame
type to the first one detected.
•
EN_8023
: Limits the frame type to IPX over IEEE 802.3
frames. All others will be discarded.
•
EN_II
: Limits the frame type to IPX over Ethernet Frames.
All others will be discarded.
•
EN_8022
: Limits the frame type to IPX over IEEE 802.2 with
IEEE 802.3 frames. All others will be discarded.
•
EN_SNAP
: Limits the frame type to IPX over SNAP with IEEE
802.3 frames. All others will be discarded.
Note that the IPX/SPX protocol must be enabled in the
Netware
menu before you can configure frame types. See “Setting
Network Protocols” on page C.7.
U
SING
Y
OUR
P
RINTER
ON
A
N
ETWORK