Filter
Top Products
A.9
APPENDIX
When selecting labels, consider the quality of each component:
• Adhesive: The adhesive material should be stable at
200 °C (392 °F), the printer’s fusing temperature.
• Arrangement: Only use labels with no exposed backing
between them. Labels can peel off sheets with spaces
between the labels, causing jams.
• Curl: Prior to printing, labels must lie flat with no more than
13 mm (.5 in.) of curl in any direction.
• Condition: Do not use labels with wrinkles, bubbles, or other
indications of separation.
See “Printing on Labels” on page 4.10.
Transparencies used in the printer must be able to withstand
200 °C (392 °F), the printer’s fusing temperature.
See “Printing on Transparencies” on page 4.11.
CAUTION: To avoid damaging the printer, use only
transparencies recommended for use in laser printers.
CAUTIONS:
• To avoid damaging the printer, use only labels recommended
for laser printers.
• To prevent jams, always use the face-up output slot.
• Never print on the same sheet of labels more than once or print
on a partial sheet of labels.
Labels
Transparencies
Paper Specifications