Filter
Top Products
Application Example
50
890USE19600 April 2004
Using CMD to Configure an STB Island on INTERBUS
Introduction Use these directions to add an Advantys STB island slave to your INTERBUS
network using Phoenix Contact’s CMD software. The employed master device is a
controller board that you select. In this example, we will use a PC with an IBS/4K
controller board. The stages of this process are described in the following table:
The CMD
Workspace
In this configuration example, you will add a master device and an Advantys STB
island slave to your configuration using CMD.
The CMD workspace should resemble the following figure after you’ve added the
controller board and INTERBUS NIM slave to your network configuration with the
following instructions:
Stage Description
1 Add the controller board
2 Add the island slave
3 Save and download the configuration