Filter
Top Products
11-13
[4] Setting procedure
Set parameters of the master station following the procedure below.
[ ] : See page in chapter 11
to are equivalent to number of page 11-5, and 11-6.
Start slave station PC operation
Turn ON the power of master station PC
[ 14 ]
Connect support tools
[ 14 ]
Stop PC operation
[ 14 ]
[ 14 ]
Stop operation of data link (007777(8) =00(H))
[ 14 ]
Set top address of the relay link area on the master station
[ 15 ]
Set data link function (004002(8) =01(H))
[ 15 ]
Set number of connecting stations
[ 15 ]
[ 15 ]
Set top address of register link area on master stations
[ 16 ]
Set top address of register link area on slave station 01 to 77(8) (at standard function)
/number of off set bytes (save memory function)
[ 17 ]
Set number of sending bytes of the master station relay link
[ 17 ]
Set number of sending bytes of the slave station 01 to 77(8) relay link
[ 18 ]
Set number of sending bytes of the master station register link
[ 18 ]
[ 18 ]
Set number of sending bytes of the slave station 01 to 77(8) register link
Whether the station number information should be output or not
Set connection status of slave stations
[ 19 ]
[ 19 ]
Set top address of flag area
[ 20 ]
Writing to EEPROM, start operation (007777(8) =81(H))
[ 21 ]
PC operation
[ 21 ]
End
Set top address of relay link area on slave station 01 to 77(8) (at standard function)
/number of offset bytes (at save memory function)
V2