Filter
Top Products
14-1
After stopping operation, record the parameters of the JW-21MN onto the memory of the personal computer.
(3) Start operation of the JW-21MN
After recording the parameters onto the personal computer, start operation of the JW-21MN.
Select "Start operation."
Record and load by ladder software (JW-92SP, JW-50SP)
<Record>
(1) Stop operation of the JW-21MN
(2) Record onto the personal computer
Select "PC TRANS."
Select "Read."
Select "DL. M. stn. PARAM." or "DL. S. stn.
PARAM."
When the connected JW-21MN is master station, select "DL.
M. stn. PARAM." When the connected JW-21MN is slave
station, select "DL. S. stn. PARAM."
After selecting "PC stop," press the "Enter"
key.
Select "Read out PARAM" and press the "Enter" key.
Start reading to memory of the personal computer.
Chapter 14: Support Tools
The following support tools are available to record (store), and load the contents of the parameter
memory.
(Make sure to save the set parameters onto a floppy diskette.)
Start operation of the JW-21MN
(4) Record onto a floppy diskette
Write (record) the memory contents of the personal computer onto a floppy diskette.
Select "FD TRANS."
Select "Save."
Select "DL. M. PARAM." or "DL. S. PARAM."
When the memory contents of the personal computer are for a master station, select
"DL. M. PARAM." When the memory contents of the personal computer are for a
slave station, select "DL. S. PARAM."
Input a file name to record.
Input comments.
Press the "Enter" key.
Start recording onto the floppy diskette.
JW-21MN
Connection cable
JW-22KC/24KC
JW-50SP
Applicable floppy diskettes
Model name
Ladder software (JW-92SP, JW-50SP) 3.5-inch 2DD/2HD, 5-inch 2DD/2HD
Multipurpose programmer (JW-50PG) 3.5-inch 2DD
Ladder processor II (Z-100LP2S) 3.5-inch 2DD