Filter
Top Products
6-10
KEY OPERATOR PROGRAMS
Device settings
These programs are used to disable use of a
peripheral unit when it malfunctions or to prohibit use
of it temporarily. Also these programs can be used
for setting again the functions of peripheral units
based on the usage patterns.
In “Device Settings”, the following programs can be
set.
●
Disable duplex unit
●
Disable stapler unit
●
Disable paper desk drawers
●
Disable finisher
●
Disable mail-bin stacker
●
Saddle stitch adjust
Disable duplex unit
This program is used to disable duplex printing when
the duplex module malfunctions. If this program is
set, only one-sided printing can be performed.
Disable stapler unit
This program is used to disable stapling when the
stapler unit of the finisher or saddle stitch finisher
malfunctions.
Disable paper desk drawers
This program is used to disable use of the stand/3 x
500 sheet paper drawer or stand/MPD & 2000 sheet
paper drawer when it malfunctions.
Disable finisher
This program is used to disable use of the saddle
stitch finisher or finisher when it malfunctions.
Disable mail-bin stacker
This program is used to disable use of the mail-bin
stacker when it malfunctions.
Saddle stitch adjust
This program is used to adjust the stapling position
(folding position) when using the saddle stitch function
by installing a saddle stitch finisher.
The value can be adjusted in 0.1 mm increments
within ±3.0 mm from the reference position for each
paper size.
{Max. +3 mm} {Min. -3 mm}
{Position adjusted to the plus direction}
{Position adjusted to the minus direction}
{Reference position}
Print key operator program list
This program is used to print out the list of the key
operator programs.
[When using the operation panel with touch panel:]
Key operator programs of the copier feature, facsimile
feature, and network scanner feature can be printed.
Key operator code change
This program is used to change the key operator
code number (password) from the factory default
setting or from the number that has been set.
The key operator must register the key operator code
number (password). The key operator code number
must be entered to access the key operator
programs. Only one key operator code number
(password) can be input. For the factory default key
operator code number (password), see page xxxx.
The key operator must detach the page and store it.
Also be sure to remember the registered key operator
code number (password).