Sierra Wireless RJ-11 Network Card User Manual


 
Host RJ-11 IP Gateway
10 2120028
Host RJ-11 IP Gateway Defaults
Phoneport:8databits,noparity,and1stopbit(8N1).
Protocol:American/Bell212A.
Maximumbaud:2400.
DHCPclient:disabled.
IPAddress:192.168.1.3.
Note: If you are using the
defaults for the Host RJ-11 IP
Gateway, you can skip this
section and connect your Host
RJ-11 IP Gateway directly to
your Raven X and device and
network.
Configuring the Host RJ-11 IP Gateway
1. ConnecttheHostRJ11IPGatewaytopowerandconnect
theEthernetcablefromyourRavenXcomputertothe
HostRJ11IPGateway.
Caution: If the modem has been disconnected from power between
the steps of the previous section and this section, it may have a
different IP address than what you noted. You will need to reconnect
the modem to your computer, reconnect Wireless Ace and repeat step
5 above (page 7) to determine the new IP address given to the
modem by the cellular provider
2. Type“http://”,the IPaddressfromthemodem,and
“192.168.1.3:9080”(seetheexampleinthescreenshot
below)intheAddressorLocationbarandpresstheenter
key.
Figure 2-6: Web Browser : Enter the Location
Note: Since many cellular carriers block the standard web browser
ports (80 and 8080), the Host RJ-11 IP Gateway uses 9080 by default
as the port for the web-based interface.
Thewebbasedinterfacewillopen.Ontheleftsideofthe
windowaremenuoptions.Thecentralareaofthewindowis
theworkingarea(showninthecloseupscreenshotsforthe
configurationsettings).
http:192.168.1.3:9080