SMC Networks SMC6726AL2 Switch User Manual


 
C
OMMAND
L
INE
I
NTERFACE
4-38
management
This command specifies the client IP addresses that are allowed
management access to the switch through various protocols. Use the no
form to restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
all-client - Adds IP address(es) to the SNMP, web and Telnet
groups.
http-client - Adds IP address(es) to the web group.
snmp-client - Adds IP address(es) to the SNMP group.
telnet-client - Adds IP address(es) to the Telnet group.
start-address - A single IP address, or the starting address of a range.
end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
If anyone tries to access a management interface on the switch from
an invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
When entering addresses for the same group (i.e., SNMP, web or
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.