SMC Networks SMC6726AL2 Switch User Manual


 
C
OMMAND
L
INE
I
NTERFACE
4-140
Command Usage
•If you do not enter an snmp-server host command, no notifications
are sent. In order to configure the switch to send SNMP notifications,
you must enter at least one snmp-server host command. In order to
enable multiple hosts, you must issue a separate snmp-server host
command for each host.
•The snmp-server host command is used in conjunction with the
snmp-server enable traps command. Use the snmp-server enable
traps command to specify which SNMP notifications are sent
globally. For a host to receive notifications, at least one snmp-server
enable traps command and the snmp-server host command for that
host must be enabled.
Some notification types cannot be controlled with the snmp-server
enable traps command. For example, some notification types are
always enabled.
The switch can send SNMP version 1 or version 2c notifications to a
host IP address, depending on the SNMP version that the
management station supports. If the snmp-server host command does
not specify the SNMP version, the default is to send SNMP version 1
notifications.
Example
Related Commands
snmp-server enable traps (4-141)
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#