Filter
Top Products
II-41
Making the Necessary Settings
Chapter 6 3D System
Making the Necessary
Settings
Make the settings for operating the unit in a 3D system in
the [Setup] menu.
Display the [Setup] menu by pressing the SETUP button in
the menu control block.
Setting the Signal Format and Video
Size
1
Display the [Setup] menu, select [System] menu >
[System Format], and use the corresponding knobs to
make each of the following settings.
The [Aspect] of the video is fixed at 16:9.
For details on the setting, see “Configuring the Signal Format and
Aspect Ratio” (c Basic Operation).
2
Press the V3 or V4 knob.
A message prompting you to restart the unit appears.
3
Press the V3 knob (OK).
Turning 3D Mode On
1
Display the [Setup] menu, select [System] menu > [3D
Mode], turn the V4 knob to select [On].
2
Press the V4 knob.
A message prompting you to restart the unit appears.
3
Press the V3 knob (OK), and then turn off the unit and
turn it on again.
• In 3D mode, the BKGD bus delegation button will be lit,
and the KEY, AUX 1, and AUX 2 buttons will be
disabled.
• Next transition is fixed at BKGD.
• Transition types will be fixed at MIX.
• The FTB and KEY TRANS buttons in the transition
control block will be disabled.
• The numeric keypad block will be disabled.
• In the menu control block, only the MISC, FILE, and
SETUP buttons will be enabled.
In addition, menus will be restricted as follows.
[Misc] menu
[Setup] menu
Knob Parameter Meaning Setting Value
V3 Format Signal
format
108059 (1080i/
59.94), 108050
(1080i/50), 720p59
(720p/59.94),
720p50 (720p/50)
V4 Aspect Aspect
ratio of
video
16:9
Tip
Knob Parameter Meaning Setting
Value
V4 3D Turns 3D mode on/off Off, On
Tips
Menu item Restriction
Transition
Rate (1/2)
• Only the [Effect] transition rate is enabled.
Transition
Rate (2/2)
• Setting is disabled.
Color
BKGD
• Setting is disabled.
Port Enable • [GPI] is fixed at [Disbl] (disable).
• Only [RS232C] can be selected.
Menu item Restriction
Video
(XPT)
• Movement to the sub-level setting is
disabled (assignments for cross-point
buttons are fixed).
Video
(Output)
• Movement to the sub-level setting is
disabled (assignments for video output
are fixed).
Multi
Viewer
• Only setting of the number of sub-screens
is enabled.
• Assignment of video to the sub-screens is
fixed.
GPI/Tally • Movement to the sub-level setting is
disabled.