Filter
Top Products
GM29 INTEGRATOR’S MANUAL
138
LZT 123 7361 R1B
List of result codes
10.8 ATZ Reset to Default Configuration
This command instructs the DCE to set all parameters to their default
values as specified by the user. Consider hardware configuration
switches or non-volatile parameter storage (if implemented) when using
this command.
Commands included on the same command line as the Z command will
be ignored.
ATV1/ATV=1 ATV0/ATV=0 Description
OK 0 Acknowledges execution of a command
CONNECT 1 A connection has been established; the DCE is
moving from command state to online data
state
RING 2 The DCE has detected an incoming call signal
from the network
NO CARRIER 3 The connection has been terminated or the
attempt to establish a connection failed
ERROR 4 Command not recognized, command line
maximum length exceeded, parameter value
invalid, or other problem with processing the
command line
NO DIALTONE 6 No dial tone detected
BUSY 7 Engaged (busy) signal detected
NO ANSWER 8 “@” (Wait for Quiet Answer) dial modifier was
used, but remote ringing followed by five
seconds of silence was not detected before
expiration of the connection timer
CONNECT
<TEXT>
Manufacturer-
specific
Same as CONNECT, but includes
manufacturer-specific text that may specify
DTE speed, line speed, error control, data
compression, or other status
Description Command Possible Responses
Execute AT Z •OK
• ERROR
Execute ATZ=<profile> •OK
• ERROR
Show if supported and list
available parameter range
ATZ =? Z: (list of supported
<profile>s)
<profile > Description
0 Select the user profile to restore