Filter
Top Products
13. SHORT MESSAGE SERVICES - POINT TO POINT
183
LZT 123 7361 R1B
same as specified by the send message command, +CMGS. If writing
fails, final result code +CMS ERROR: <err> is returned. See
“AT+CPMS Preferred Message Storage”, page 179.
Text Mode
Stores message (either SMS-DELIVER or SMS-SUBMIT) to memory
storage <mem2>. Memory location <index> of the stored message is
returned. By default message status will be set to ‘stored unsent’, but
parameter <stat> allows also other status values to be given. The
entering of text is done as specified in the send message command,
+CMGS. If writing fails, final result code +CMS ERROR: <err> is
returned.
Note! SMS-COMMANDs and SMS-STATUS-REPORTs cannot be stored in
text mode.
<stat> Description
2 Stored unsent message (only applicable to SMs)
<index> Description
Integer type Value in the range of location numbers supported by the associated
memory
<length> Description
Integer type Value indicating in PDU mode (+CMGF=0), the length of the actual
TP data unit in octets (i.e. the RP layer SMSC address octets are not
counted in the length)
<pdu> Description
... In the case of SMS: GSM 04.11 SC address followed by GSM 03.40
TPDU in hexadecimal format: ME/TA converts each octet of TP data
unit into two IRA character long hexadecimal number (e.g. octet with
integer value 42 is presented to TE as two characters 2A (IRA 50 and
65))
In the case of CBS: GSM 03.41 TPDU in hexadecimal format
Description Command Possible Responses
Write message to memory AT+CMGW [=<oa/da>
[,<tooa/toda>[,<stat>]]]
<CR>
Text is entered <ctrl-Z/ESC>
• +CMGW: <index>
• +CMS ERROR: <err>
•OK
• ERROR
Show if the command is
supported
AT+ CM GW =? •OK
• ERROR
<stat> Description
2 Stored unsent message (only applicable to SMs)