Filter
Top Products
GM29 INTEGRATOR’S MANUAL
250
LZT 123 7361 R1B
“X” is the numbering (starting with 1) of the call given by the sequence
of setting up or receiving the calls (active, held or waiting) as seen by
the served subscriber. Calls hold their number until they are released.
New calls take the lowest available number. Where both a held and a
waiting call exists, the above procedures shall apply to the waiting call
(i.e. not to the held call) in conflicting situation.
Note! The “directory number” case shall be handled with dial command D,
and the END case with hangup command H (or +CHUP).
16.14 AT+CLIP Call Line Identification Presentation
This command enables a called subscriber to get the identity of the
calling line when receiving a mobile terminated call. The “Set”
command enables or disables the presentation of the CLI (calling line
identity) at the TE. It has no effect on the execution of the
supplementary service CLIP in the network.
When the presentation of the CLI at the TE is enabled (if the calling
subscriber has allowed it), the unsolicited result code
+CLIP:<number>,<type>,,,<alpha> response is returned after every
RING (or +CRING:<type>) result code sent from TA to TE (refer to AT
+CRC in section ???????).Whether this will be used when a normal
voice call is answered is a manufacturer-specific option.
2 Places all active calls (if any exist) on hold and accepts the other (held
or waiting) call
2X Places all active calls on hold, except call X with which
communication is supported
3 Adds a held call to the conversation
4 Connects the two calls and disconnects the subscriber from both calls
(explicit call transfer)
<n> Description
Description Command Possible Responses
Requests calling line
identification.
AT+CLIP=<n> OK
Read the current setting AT+ CL IP ? +CLIP: <n>,<m>
Show if the command is
supported
AT+ CL IP =? +CLIP: (list of supported
<n>s)
<n> Description
0 Disables presentation. Default value
1 Enables presentation