Filter
Top Products
Hardware Setup SY-5STM
35
2-4 SOUND SETTINGS (J4, J5, J2)
The onboard audio features of your mainboard are controlled by
jumpers J4, J5, J2.
Choose the available sound options among the following table:
Sound Settings J4 J5 J2
Onboard Sound: Enable *
open* open*
Onboard Sound: Disable
short short
Microphone: Stereo *
short*
Microphone: Mono
open
* Starred items refer to default settings.
2-5 WAKE-ON-LAN CONNECTOR (JP44)
Attach the 3-pin connector from the LAN card which supports the
Wake-On-LAN (WOL) function to the JP44 connector on the
mainboard. This WOL function lets users wake up the connected
computer through the LAN card.
Please install according to the following pin assignment:
2-6 CMOS CLEAR JUMPER (JP5)
Clear the CMOS memory by momentarily shorting pin 2-3 on jumper
JP5, and then by shorting pin 1-2 to retain new settings. This jumper
can be easily identified by its white colored cap.
CMOS Clearing Clear CMOS Data Retain CMOS Data
(Default)
JP5 Setting
Short pin 2-3 for
a few seconds to
clear the CMOS
Short pin 1-2
to retain new
settings
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
3
2
1
3
2
1
Wake-On-LAN
JP44 Pin Assignment
5V GND
SENSOR
1 2
3