SOYO SY-5S Computer Hardware User Manual


 
SiS VGA Driver Installation SY-5STM
90
11. In the detailed configuration for SiS 5597/5598 drivers, follow
the instructions that appear on the screen and make your own
choices.
12. After the detailed configuration, you will enter the 3DS main
display screen and you may begin your 3D Studio work in the
environment you just made.
13. Once completing the detailed configuration, you may enter 3D
Studio by typing: \3DS3\3DS <Enter>.
14. To change your video configuration again, follow the procedures
mentioned above.
6-4 ET24 (Chinese)
This is an ETen Chinese System Display driver (ETDSPDRV.COM)
for SiS VGA chips.
1. To install this driver, Copy SVGAUTL.EXE to
<drive>:\<directory>, i.e.C:\SiS.
2. In default mode (1024x768x16c, 87Hz Interlaced), this Display
Driver will force ET Chinese System to software scrolling
(scrolling with slower speed). To make use of hardware
scrolling, you must set the Frame Rate to non-interlaced mode
before entering ET Chinese system. Do so by adding the
following line to the top of the Autoexec.bat or ET24.bat.file. The
last two number of the line correspond with the refresh rate of
your monitor:
<drive>:\<directory>\SVGAUTL\F2:60 (for 60Hz non-interlaced
mode)
3. You may also use F2:70 and F2:75 for 70Hz and 75Hz non-
interlaced modes. Here is an example:
C:\SiS\SVGAUTL\F2:60 to Autoexec.bat or ET24.bat
4. Please note that some monitors may not support 70Hz non-
interlaced modes.