Star Micronics Dot Impact Printer Printer User Manual


  Open as PDF
of 104
 
3-70STARCommandSpecications
Rev. 0.70
ESC GS # m N n1 n2 n3 n4 LF NUL
[Name] Set memory switch
[Code] ASCII ESC GS # m N n1 n2 n3 n4 LF NUL
Hexadecimal 1B 1D 23 m N n1 n2 n3 n4 0A 00
Decimal 27 29 35 m N n1 n2 n3 n4 10 0
[DenedArea] m=87,84,44,43,45(m=“W”,“T”,“,”,“+”,“-”)
48 ≤ N ≤57(”0”≤ N ≤“9”),65≤ N ≤70(”A”≤ N ≤“F”)
48 ≤ n1 ≤57(”0”≤ n1 ≤“9”),65≤ n1 ≤70(”A”≤ n1 ≤“F”)
48 ≤ n2 ≤57(”0”≤ n2 ≤“9”),65≤ n2 ≤70(”A”≤ n2 ≤“F”)
48 ≤ n3 ≤57(”0”≤ n3 ≤“9”),65≤ n3 ≤70(”A”≤ n3 ≤“F”)
48 ≤ n4 ≤57(”0”≤ n4 ≤“9”),65≤ n4 ≤70(”A”≤ n4 ≤“F”)
[Initial Value] ---
[Function] Sendscommandtowriteafterdeningmemoryswitchusingthedenitioncommandspeciedbythe
followingclassestosetthememoryswitch.Theprinterisautomaticallyresetafterwritingthesettingdened
bythatcommandtothenon-volatilememory.
Do not turn off the power to the printer while sending commands to the non - volatile memory.Doing so will
destroythememoryswitchsetting.Itisalsopossibleforallmemoryswitchsettingstobecomeoffsettotheir
initial, default settings.
Consider the life of the non-volatile memory and avoid over-sue of this command.
Function Class m N n1 n2 n3 n4
DataDenition(DataSpecication) Denition “,” N n1 n2 n3 n4
Datadenition(setspeciedbit) Denition “+” N n1 n2 n3 n4
Datadenition(clearspeciedbit) Denition “-” N n1 n2 n3 n4
Denitiondatawriteandreset Write “W” Fixedat“0” Fixedat“0000”
Denitiondatawriteandresetandtestprint Write “T” Fixedat“0” Fixedat“0000”
• m: Mode Selection
•N: Memoryswitchnumbertospecify
•n1n2n3n4: Specieddatam=“,”→Specieddata
  m=“+”→Bitnumbertoset
  m=“-”→Bitnumbertoclear
Note The status of this command varies according to the model, so check the special appendix.
 previous next