Filter
Top Products
● Printer does not feed paper
Probable Cause
Paperisjamming.
Bailleverisclosed
before paper goes
throughthebaille-
verlocation.
Adjustment lever
is set incorrectly.
Fanfold form is
parked.
Action
Remove all forms and pieces of paper.
Open thebail lever. Bail leverautomatically closed when
the paper goes through the bail lever location.
Check the settingoftheadjustmentlever. See “Adjusting
the printing gap” in Chapter 3.
Move bail lever forward to unpark the fanfold paper.
● Line spacing is incorrect or overprinting occurs
Probable Cause
The tractor posi-
tions are incor-
rectly adjusted.
Incorrect emula-
tion is selected.
Problem with the
application
program.
Platen knob was
manually turned
while the Power
indicatorwas on.
Forms are jam-
ming between
printing surface
and the print
head.
Action
Adjustthetractorpositions.See“Loading fanfoldforms”
in Chapter 3.
Select the other emulation with the EDS setting. See
Chapter 5.
Refer to your application program manual.
Set the top of form. See “Top of form” in Chapter 4.
Do not manually turn the platen knob when the power is
on. Use the I
PAPER FEED [button.
Reset adjustment lever. See “Adjusting the printing gap”
in Chapter 3.
59