Filter
Top Products
INTERFACE CONVERTER (SPC-8K)
To run the printer in serialmode, you should use the optional Serial/Parallel
Converter (SPC-8K).
The procedure to install the Converter is:
1.
2.
3.
4.
5.
-
SettheDIP switchesonthe SPC-8Kbefore attaching ittotheprinter.(See
next page for detailed information.)
Turn off the power switch and disconnect the power cord from the power
source.
Disconnect the interface cable if attached.
Connect the Parallel connector to the printer.
Move both clips insidethe extended prongs on the sidesof the plug until
you hear a click,
1
Figure 7-21.Connect the Parallel connector to the printer.
6. Connect the Serial connector to your computer.
NOTE: Place the Converter on a table in order not to damage the cable.
[CORRECTMETHOD] [INCORRECTMETHOD]
Figure 7-22.Placethe converter on a table,
78