Filter
Top Products
XLi IEEE 1588 Clock 97
997-01510-03, Rev. C, 12/12/2006
2
5
1
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
To test if the XLi’s network port has a good connection, enter the following using in a serial port session:
>f100 PI<CR>
The Xli responds:
PING : REMOTE HOST FOUND.<CR><LF>
or it responds:
PING : REMOTE HOST NOT FOUND.<CR><LF>
F100 PN – Change User Name
Use function F100 PN to change a user name. In a network port session, F100 PN changes the name of
the user you logged in as; operator or guest. In a serial port session, F100 PN changes the name of the
operator user. See “
Command Line Interface” on page 29.
To change the user name, enter:
F100<S>PN<CR>
where:
The XLi responds:
ENTER NEW USER NAME:
When you enter a new user name, The XLi responds:
CONFIRM NEW USER NAME:
Enter the same new user name again, to confirm the spelling. If the same new user name has been
entered twice, The XLi responds:
OK<CR><LF>
In this case, the new user name will be used for the next login using the command line interface.
However, if the new user name is entered differently the second time, The XLi responds:
ERROR: USER NAMES DO NOT MATCH. NEW USERNAME REJECTED!<CR><LF>
F
= ASCII character F
100 = unit function number
<S> = space
PN = specify User Name command
<CR> = input line terminator