Filter
Top Products
36 XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
1
F66 – Daylight Saving Time (DST)
Mode
K,N,S,W Schedule when DST starts and ends (Local time only)
F69 – Time Mode
K,N,S,W Set the time scale (TAI, GPS, UTC, Standard, Local) output
by the IEEE 1588 card and displayed on the front panel of
the XLi. (TAI is the recommended setting).
F71 – Oscillator Statistics
K,N,S,W Display the XLi oscillator’s phase, offset, drift, and DAC
values
F72 – Fault Status
K,N,S,W View clock and power supply fault status
F73 – Alarm Control / Status
K,N,S,W View the status of all the alarm indicators. Enable/disable
alarms for each indicator. Set alarm thresholds. Enable or
disable LED blink
F74 – Clock Source Control
K,N,S,W Select the pattern of switching between reference sources
F90 – Code Output Configuration
K,N,S,W Configure settings for CODE – time code output
F100 – Network Port Configuration &
XLi Firmware
K,N,S,W Configure the standard network port settings
F100 EA – Ethernet Address
K,N,S,W Display the Ethernet (MAC) address
F100 IP – IP Address
K,N,S,W Configure the IP address
F100 SM – Subnet Mask
K,N,S,W Configure the subnet mask
F100 G – Gateway
K,N,S,W Configure the default gateway
F100 IC – Network Port Settings
K,N,S,W Display all the standard network port’s settings
F100 L/LOCK/UNLOCK – Remote
Lockout
K,N,S Lock remote access to the XLi’s standard network port
F100 L – Remote Lockout
K,N*,S Display the status of F100 LOCK
*Locked through the network port, serial port, and keypad.
Can be unlocked only through the keypad or serial port.
F100 ST – Self Test Status
K,N,S Display the XLi’s self test results for Flash CRC, RAM,
Serial Port, and NVRAM
F100 BH – Burn Host
N,S Upgrading system firmware: select the FTP host, path, and
filename of the system firmware
F100 BUB – Burn BootLoader
N,S Upgrading system firmware: ‘burn’ the bootloader file (*.bt)
selected using F100 BH to flash memory
F100 BU – Burn
N,S Upgrading system firmware: ‘burn’ the system firmware file
(*.bin) selected using F100 BH to flash memory
F100 BF – Burn File System
N,S Upgrading system firmware: ‘burn’ the file system file (*.fs)
selected using F100 BH to flash memory
F100 BUFP – Burn FPGA Firmware
N,S Upgrading system firmware: burn the FPGA program file
(*.bin) selected using F100 BH to the flash memory
F100 CONFIG – Configure NTP &
SNMP
N,S,W*
a
Transfer the SNMP configuration file between the XLi and
an FTP server for editing
F100 J – Factory Mode Jumper
N,S View the status of the factory mode jumper, which is used
by factory technicians. Not of interest to most end users.