Filter
Top Products
7265 Programmer’s Manual
10
Copyright © 2004 TallyGenicom Chapter 2 ANSI
Commands Description
DEL DELETE
DEL is a printable character, or is a valid graphics data byte if received
in dot
g
r
aphics
mode.
Dec 127 Hex 7F
ESC [(p1);
(p2)<SP>~
SELECT EMULATION
If p2 is 0, which is the default, then the current settings in the printer remain in effect
through the emulation change to the extent that selected features are supported in
the target emulation. This affects such things as, font selection, character pitch,
margins, tabs, and so forth. If p2 is 1, then the status of such parameters reverts to
defaults dependent on the selected emulation.
p1 selects
0 GENICOM ANSI
1 Tally ANSI
2-21 Reserved
22 Epson FX286e
p2 selects
0-1 full reset
Example: Select Epson emulation with full reset:
Dec 27 91 50 50 59 49 32 126 Hex 1B 5B 32 32 3B 31 20 7E
ESC [(p1)p SELECT PAPER PATH
p1 selects
08 unload current path
10 unload current path and load tractor 2
12 unload current path and load tractor 1
Forms in the current path should be torn off before changing paper paths. If
you send a command to change paper paths and there is more paper
downstream of the print head than 1/2 times the current form length or six
inches, whichever is greater, then the printer returns paper to the position that
was current before the command was received, and a fault condition is set.
If you send a command to change paper paths and the target path is the
current path, then the printer executes a form feed. If you load tractor 2
Example: Unload tractor 1 and load tractor 2:
Dec 27 91 49 48 112 Hex 1B 5B 31 30 70
when tractor 2 is not installed, the command will be ignored.