Filter
Top Products
7265 Programmer’s Manual
11
Copyright © 2004 TallyGenicom Chapter 2 ANSI
Commands Description
ESC c RESET TO INITIAL STATE
Recalls the user format presently assigned to the current paper path.
Dec 27 99 Hex 1B 63
ESC [(p1)t ENABLE/DISABLE OVERSIZED/EXPANDED/BAR CODE MODES
p1 Effect Page
0 reset special modes
1 select oversized printing 4-2
2 select expanded printing 4-2
3 select bar code 3-6
Oversized printing and bar codes are explained in separate chapters. When
expanded printing is selected, the current font is expanded horizontally and vertically
in 100% increments according to expansion factors specified by ESC
[(p1);(p2)<SP>B (see page 11). The range of expansion is 1x through 8x.
Example: select expanded printing
Dec 27 91 50 116 Hex 1B 5B 32 74
ESC [(p1);
(p2)<SP>B
GRAPHIC SIZE MODIFICATION
Sets the size of expanded and oversized characters. The effect of this command on
oversized is explained in a separate chapter.
When expanded print is selected, the argument units for parameters p1 and p2 are
percentages of the vertical and horizontal dimensions of the current font. Parameter
p1 controls the vertical expansion and p2 controls the horizontal expansion. The
argument limits for expanded print are 800;800 (8x the parent font size).
Oversized enables much larger expansions. Parameters are rounded down to the
nearest 100.
Note: This printer goes into expanded mode immediately on receiving this
command. Any text between this sequence and a countermanding ESC [(p1)t
sequence (see page 11) is printed according to the specified expansion.
If height and width are different values, the height will be set the same as the width.
ESC [(p1);
...(pn)h
SET MODE (ANSI)
p Effect
20 auto CR on LF
Dec 27 91 50 48 104 Hex 1B 5B 32 30 68