Filter
Top Products
Commands not implemented in the 7265 ANSI Emulation
ESC ] p1;pn<ST> User Defined Character Substitution (GENUDS)
ESC ] p1;p2;p3;data<ST> Operating system command (Load Mode OSC)
ESC [ p1;p2 SP ~ Selects emulation (GENEMU)
ESC [ p1;pn { Unidirectional Printing (GENUPD)
ESC [ p1;p2;p3 SP | Customer Setup Save/Unsave (GENCSX)
ESC [ p1;pn p Assign Source for Forms (GENASF)
ESC [ p1 x Selects National character set (Select National Characters - GENSNC)
ESC k Print Test Character (GENPTC)
ESC Q or PU1 Executes Self Test
Exceptions
1.) Barcode ratios are controlled by one parameter that affects both width and height.
2.) Block characters print at a fixed size.
3.) Block characters printed with a fixed rotation.
4.) The Genicom printer saves ESC sequence changes to powerup; we load from the powerup menu.
5.) <DEL> character prints a space; Genicom prints a “house” character.
6.) Across 13.6 inches we print one less character per line in the following CPI's:
6, 6.25, 6.67, 8.33, 8.57, 9, 12, 12.5, 13.3, 17.14 and 18
7.) If we set Auto CR to ON then form feeds also get a CR, where Genicom does not add CR to form feeds.
Genicom does add CR to FF if "Auto CR on Vertical Tab" is enabled.
8.) Different combinations of adding and removing vertical tabs will produce different results compared to the
Genicom printer.
9.) Differences when mixing some form lengths with top and bottom margins.
10.) Some illegal parameters are treated different than the Genicom printer.
11.) Default horizontal and vertical tabs are not defined at power up.