Filter
Top Products
4-24
4 Operations4 Operations
4 Operations4 Operations
4 Operations
TELEDYNE ANALYTICAL INSTRUMENTS
7. Status page five shows the time and date of the last time
the alarm was triggered for each of the five program-
mable alarms.
8. Status page six shows the set-up for the serial port, and
allows you to reconfigure the serial port. Press EDIT to
bring up the following screen.
Press NEXT to go to status page 7.
9. Use the SELEC, UP and DOWN keys to select the de-
sired serial port configuration, and press ACCPT.
Baud rate:Baud rate:
Baud rate:Baud rate:
Baud rate: 300–2400
Parity:Parity:
Parity:Parity:
Parity:Odd, Even, or None
Mode:Mode:
Mode:Mode:
Mode: Monitor, Remote, or Off
ASCII Data Bits:ASCII Data Bits:
ASCII Data Bits:ASCII Data Bits:
ASCII Data Bits:7 or 8
Stop Bits:Stop Bits:
Stop Bits:Stop Bits:
Stop Bits: 1 or 2
Modem:Modem:
Modem:Modem:
Modem: On, Off or Auto
Output Interval for Monitoring:Output Interval for Monitoring:
Output Interval for Monitoring:Output Interval for Monitoring:
Output Interval for Monitoring: 1–32000 sec.
Transmit/Receive Line Terminators:Transmit/Receive Line Terminators:
Transmit/Receive Line Terminators:Transmit/Receive Line Terminators:
Transmit/Receive Line Terminators: CR or
CRLF
10. Status page seven allows for configuration of the mo-
dem/remote. Press EDIT to change the configuration.
•
Modem ModeModem Mode
Modem ModeModem Mode
Modem Mode: AUTO/OFF/ON
•
Modem StatusModem Status
Modem StatusModem Status
Modem Status: NO (set by system)
•
Login AccessLogin Access
Login AccessLogin Access
Login Access: LOCAL (set by system)
•
Phone JackPhone Jack
Phone JackPhone Jack
Phone Jack: SINGLE/MULTI, RJ12
•
Comm. Std. for 1200BComm. Std. for 1200B
Comm. Std. for 1200BComm. Std. for 1200B
Comm. Std. for 1200B: BELL USA/CCITT
11. After pressing EDIT, a cursor will appear and you will
be able to edit the settings. Press ACCPT when done.
Pressing INIT in status page seven (step 10) takes you
to the screen at the top of the next page and gives you
the option of either checking for a modem, or setting up
the modem. Set-up sets up the modem for auto answer
and other communication protocols.