Filter
Top Products
G
BIOS Messages
Power-up self-tests are the system tests and component initialization processes performed by the AT-compatible ROM
BIOS in the TravelMate 2000 Computer. The central hardware is tested and initialized first. Proper functioning of the
central hardware is required before further system tests can be run. In general, a failure in a test of the system board
or its components will result in the sounding of a beep, and a halted system. A failure in add-on boards or memory is
reported on the screen.
There are two types of messages displayed if the Travelmate 2000 fails one of the power-up tests:
Error messages indicating a failure in the hardware, software, or firmware
Informational messages about the power-up and booting processes
Power-up messages are fisted below, with possible causes and solutions.
Messages that do not appear in this list indicate hardware faults that can be solved only by internal checks. Contact
your authorized Texas Instruments dealer or Texas Instruments Service Center.
Power-On Self Test Error Messages
Diskette Drive X The optional Floppy Drive Unit has
seek failure failed-Run the DIAG program to
check the Floppy Drive Unit, then
contact your Texas Instruments
dealer.
Diskette read The floppy is either notformatted or
failure defective-Replace with a formatted
floppy.
BIOS Messages G-1