Filter
Top Products
Datacryptor Ethernet User Manual Installation
1270A450-005 - June 2008 Page 21
Port Cabling Supplied By
Network and Host
Port
For the 100 Mb Ethernet unit: Category 5 or above
RJ-45 connector.
For the 1 Gig and 10 Gig Ethernet units:
Dependant on
the SFPs or XFPs ordered with the unit. The options are
Category 5 or above RJ 45 connector. 850nm Multi-mode
fiber. 1310nm or 1550nm Single mode fiber.
Customer
Shielded Category 5 straight through cable (STP), RJ-45
connector.
Used when connecting through a LAN.
Customer 10/100 Ethernet
Management Port
Category 5 crossover cable with RJ-45 connector.
Required for a direct connection between the management
station and the Datacryptor.
Customer
RS-232 Craft Port Shielded copper serial cable, RS-232 DB9 connector
(female to male)
Thales
Power receptacles Power supply cables Thales
To meet the requirements of FCC Part 15 and the Directive 89/336/EEEU EMC C, use only
shielded cables (DB-9 null modem cables and Category 5 STP cables).
To Cable the Datacryptor
The Host and Network interface transceivers that are used with the 1 Gig and 10 Gig Ethernet
units are shipped separately from the Datacryptor unit, and therefore must be inserted before
proceeding with the cabling operation.
The connections are the same when using any of the three types of Ethernet unit. The
illustration below shows a 1 Gig Ethernet unit – please note that the management ports of the
100 Mb Ethernet unit are on its front panel.
• Either connect the RS-232 craft port directly to a PC or workstation using the supplied DB-9
null modem cable, or
• Connect the 10/100 Ethernet management port for management access:
− If connecting to a LAN, use a Category 5 STP straight-through cable with an RJ-45
connector.
− If connecting directly to a PC, use a shielded Category 5 crossover cable and make
sure that the PC and management port IP addresses are on the same subnet.