Filter
Top Products
Datacryptor Ethernet User Manual Element Manager Reference
1270A450-005 - June 2008 Page 61
Note: The loopback mode is regarded as a transient feature intended purely as an aid to
troubleshooting. Therefore when the unit is rebooted the loopback options are set
to Disabled.
The IP Management Tab
The properties on the IP Management tab control the IP addressing of the unit.
They are as follows:
• Control Port – the IP address and net mask of the unit’s Control Port, this value is only
used if the PPP does not negotiate another value
• Network - the IP address and net mask of the unit’s Network Port.
• Ethernet - the IP address and net mask of the unit's Ethernet (management) Port.
• Control Port - these fields show the settings for dial up networking.
• SNMP Config – click this button to configure the SNMP trapping for this unit.
• IP Route Config - click this button to configure the IP Routing table for this unit