Filter
Top Products
Installation Datacryptor Ethernet User Manual
Page 22 THALES
Figure 5-1: Datacryptor Panel Connectors
(The 100 Mb Ethernet unit’s management ports are located on the front panel)
Power on the Datacryptor
The Datacryptor software is factory-installed on the appliance. The bootable image is stored on
compact flash. Applying power to the Datacryptor initializes the system, which includes:
• Initializing the components
• Performing hardware diagnostics
• Loading the software
• Diagnostic Boot sequence
To power on the Datacryptor
1. The 1 Gig and 10 Gig Ethernet Datacryptor appliances are supplied with two separate hot
swappable power supply units. The 100 Mb Ethernet units have a single fixed power
supply unit. The power supply units for all models of Datacryptor can be either AC or DC
(-48 V).
2. The AC power supplies are auto-sensing 100 to 240 Volts 50 to 60 Hz.
3. Before applying power to the Datacryptor verify that the voltage shown on the UL label
affixed to the unit’s back panel is appropriate for your site.
WARNING: (1 Gig and 10 Gig Ethernet units only) Infra-red radiation is emitted
from aperture ports of single mode or multi-mode transceivers when no cable is
connected. Avoid exposure and do not stare into the open apertures. Apertures
should be covered when not in use.
CAUTION: If the voltage of the Datacryptor is inappropriate for
your site, do not apply power to the appliance. Contact Customer
Support immediately.