Filter
Top Products
44
[Control]:
Select the method of flow control to be used by the RS-232C port.
QQ: READY/BUSY
Default
Other than QQ: XON+READY AUTO
Options
XON+READY AUTO, XON/XOFF AUTO, READY/BUSY RTS, XON+XOFF,
READY/BUSY
[Centro.] Group
[ACK/BUSY]:
Select Centronics ACK /BUSY signal timing.
Default TYPE 1
Options
TYPE 1 (BUSY goes LOW at the same time as ACK goes HIGH.),
TYPE 2 (BUSY goes LOW at the same time as ACK goes LOW.)
[Input Prime]:
Select whether or not a reset is performed when the Centronics nInit signal is ON.
Default Enable
Options Disable, Enable
[Plug & Play]:
Select whether or not the plug-and-play function is active on the centronics port.
Plug & Play cannot be disabled for USB interface.
Default Disable
Options Disable, Enable
[USB] Group
[USB Serial Number]:
Select whether or not USB serial numbers are enabled.
When the numbers are disabled, connection to the USB port is established.
Whenever the USB port is changed, printer driver installation is required.
When the numbers are enabled, connection to the displayed serial number is established.
Printer driver installation is required for each serial number.
Default Disable
Options Disable, Enable
A serial number is a number specific to the printer.
This setting cannot be changed.
[Auto Status Response]:
Select whether to enable or disable the auto status response for the communication via USB.
Default Disable
Options Disable, Enable