Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
7-3
Side guide
Approx. 0.5mm Approx. 0.5mm
Side guide
Slide rail
Adding Paper to the Drawers
1
Pull the drawer out carefully until it comes to a
stop.
- Be careful not to touch the drawer slide rail.
2
Place the paper in the drawer.
- Place the paper face down.
- Maximum number of sheets that can be set. Page 2-4
- Fan the paper well before placing it in the drawer.
- Do not add paper above the line indicated on the guide.
- Do not use creased, folded, wrinkled or damp sheets of
paper.
Make sure that a gap of approx. 0.5 mm (less than 1 mm in
total) is left between the paper and the side guide. If there is no
gap, this may cause paper misfeeding.
3
Push the drawer straight into the copier until it
comes to a stop.
- Be sure to push the drawer carefully and fully in.
When the paper supply in the selected drawer or Tandem LCF (Large Capacity Feeder) runs out, the
drawer or External LCF (Large Capacity Feeder)(optional) shown on the display flashes, and the following
message appears:
Add paper
Add paper as follows.
Be careful not to let your fingers be caught when closing the
drawer.
2. ADD PAPER SYMBOL