Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
7-24
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
1
Perform steps 1 to 2 of the procedure for “ 5. ADDING
STAPLES Finisher ”( Page 7-21).
When copies have not been stapled in the staple mode, the following message may be shown on the
display:
Examine stapler
This means that staples have become jammed. Remove them as described below.
Finisher
6. REMOVING JAMMED STAPLES (OPTIONAL)
2
Holding the knob, lower part
A
.
3
Remove any jammed staples using your fingertip
or something sharp.
4
Holding the knob, return part
A
to its original
position.
A
A
Stapling area
Caution
Do not touch the stapling area.
The stapler could injure you.