Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
4-9
6
Enter the distance values read in step 5 for the
specified area.
- Key in the value for X1 with the digital keys and press the
upper SET key.
- Similarly, set the values for X2, Y1 and Y2.
- When setting X1,X2,Y1 and Y2, the original scale automatically
changes to the next original scale. Set the next original scale
as same procedure.
4
Place an original on the glass to specify the area.
- Set the original face up with the bottom toward you, fit its top
left corner against the top left corner of the glass, and align it
with the original scale.
5
Using the original scale on the left and the inner
(top) scale, read the position of the desired area as
follows:
- X1 Distance from the top left to the left edge of the specified
area.
- X2 Distance from the top left to the right edge of the specified
area.
- Y1 Distance from the top left to the upper edge of the specified
area.
- Y2 Distance from the top left to the lower edge of the specified
area.
Four rectangular areas can be specified on an original.
7
Press the lower SET key.
8
Place the original. (sheet original Page 2-10)
- Place the original(s) on the glass with the face down, with its
bottom toward you, with its top left aligned against the original
scale on the left side.
9
Press the START key.
Select other copy modes as required.