Filter
Top Products
2 Troubleshooting Procedures
Procedure 4 Connector Check and Replacement Check
The Fingerprint sensor is connected to the system board as below.
Check 1 If any of the connections are loose, reconnect firmly and repeat Procedure 1 to 3 .
If there is still an error, go to Check 2.
Check 2 The Fingerprint sensor may be damaged. Replace it with a new one following the
instructions in Chapter 4, Replacement Procedures and check the operation. If the
problem still exists, perform Check 3.
Check 3 The web camera/digitizer/fingerprint sensor /sw board cable may be damaged.
Replace it with a new one following the instructions in Chapter 4, Replacement
Procedures. If the problem still exists, perform Check 4.
Check 4 The system board may be damaged. Replace it with a new one following the
instructions in Chapter 4, Replacement Procedures.
2-64 [CONFIDENTIAL] PORTEGE M700/M750 Maintenance Manual (960-661)