Filter
Top Products
MR-2017/2020 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND ASSEMBLY
4 - 10
[F] Registration roller
[G] Exit roller
(1) Take off the feeder lower guide.
( P. 4-9 "[E] Feeder lower guide")
(2) Take off the original feed motor drive section.
( P. 4-16 "[A] Original feed motor (M1)")
(3) Remove 1 E-ring and 1 bushing from the
front side of the registration roller shaft. Also,
remove 1 bushing, 1 pulley, 1 E-ring and 1
bushing from the rear side of the shaft, and
then take off the registration roller.
Fig. 4-28
(1) Take off the front cover.
( P. 4-1 "[A] Front cover")
(2) Take off the original feed motor drive section.
( P. 4-17 "[B] Original feed motor drive
section")
(3) Remove 1 screw, 1 leaf spring, 1 clip and 1
bushing from the rear side of the exit roller
shaft.
Fig. 4-29
(4) Remove 1 clip, 1 pulley, 1 pin, timing belt and
1 bushing from the front side of the exit/
reverse roller shaft.
Fig. 4-30
Bushing
Pulley
E-ring
Registration roller
Bushing
Bushing
E-ring
Clip
Bushing
Leaf spring
Clip
Pin
Bushing
Pulley
Timing belt