Filter
Top Products
MR-2017/2020 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND ASSEMBLY
4 - 16
4.3 Motor / Motor drive section
[A] Original feed motor (M1)
(1) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(2) Disconnect 1 connector, and then remove 1
spring. (Spring: Outside diameter of coil –
ø9.6 mm, acceptable turns of coil – 12 turns)
Fig. 4-45
(3) Remove 3 screws, and then take off the orig-
inal feed motor with its bracket.
Note: Note:
When the unit is being assembled, tempo-
rarily tighten the screws removed at step (3)
and then attach the spring removed at step
(2). Then fully tighten these screws.
Fig. 4-46
(4) Remove 2 screws and take off the original
feed motor.
Fig. 4-47
Connector
Spring
Original feed motor
Original feed motor